MIL-PRF-31031B
5. PACKAGING
5.1 Packaging requirements. For acquisition purposes, the packaging requirements shall be as
specified in the contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-
house contractor personnel, these personnel need to contact the responsible packaging activity to
ascertain packaging requirements. Packaging requirements are maintained by the Inventory Control
Points packaging activity within the Military Service or Defense Agency, or within the military service's
system commands. Packaging date retrieval is available from the managing Military Department's or
Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible
packaging activity.
6.NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. Connectors and fittings covered by this specification are intended for use in radio
frequency applications up to the frequency specified (see 3.1).
6.2 Acquisition requirements. Acquisition documents are to specify the following:
a. Title, number, and date of the specification.
b. Title, number, and date of the applicable specification sheet, and the complete PIN (see 1.1.2
and 3.1).
c. The complete PIN of the connector or fitting ordered.
d. Packaging (see 5.1).
e. Specific finish, when required (see 3.3.1).
f. For category B connectors, the special tools which are to be used in the assembly of the
connectors.
6.3 Qualification. With respect to products requiring qualification, awards will be made only for
products which are, at the time of award of contract, qualified for inclusion in the applicable Qualified
Products List QPL No. 31031 whether or not such products have actually been so listed by that date. The
attention of the contractor is called to this requirement, and manufacturers are urged to arrange to have
the products that they propose to offer to the Federal Government, tested for qualification, in order that
they may be eligible to be awarded contracts or orders for the products covered by this specification.
Information pertaining to qualification of products may be obtained from the Defense Supply Center
Columbus (DSCC-VQ), P.O. Box 3990, Columbus, Ohio, 43218-3990 or email at
6.4 Engineering parameters. The parameters of nominal impedance, voltage rating, frequency range,
and temperature range will be as specified.
32
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business