MIL-DTL-2726/31B
REQUIREMENTS
Dimensions and configuration: See figure 1.
Contact resistance: When tested as specified in accordance with MIL-DTL-2726, the voltage
drop shall not exceed 10 millivolts. Measured between the connection
stud of the plug and the connection stud of the test receptacle.
Uncoupling force: Minimum of 10 pounds.
Stain relief: 20 pounds.
High Impact shock: Disengagement of the plug from its test receptacle under High Impact
shock shall not be considered as a failure.
Ball drop: Applicable if body material is plastic.
Contact hardness: Minimum of Rockwell 76B.
Mating receptacle: MIL-DTL-2726/32, Part or Identifying Number (PIN) M2726/32-001.
Design: Requirements for single pole plug and plug body in accordance with MIL-DTL-2726
are applicable. Polarity signs shall be molded or engraved on both front
and back sides of the plug body.
Material: Body rubber, in accordance with ASTM-D2000, M2AC 710 A13E0 or plastic,
in accordance with ASTM-D5948 type MAI-60.
PIN: M2726/31-001.
Electrical raging: 10-ampere, 125-volt.
Contact finish: Silver plate.
Verification
Verification shall be as specified in MIL-DTL-2726 and table I herein. The first article and
conformance inspections shall consist of the inspections as specified in table I, in the order shown.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business