MIL-DTL-28840/3F
QUALIFICATION: Two samples in each shell size for which qualification is desired shall be tested in
accordance with MIL-DTL-28840.
RESTRICTIONS:
Material and finish designators W and D are inactive for NAVSEA new design, unless approved by
NAVSEA.
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate
where changes from the previous issue were made. This was done as a convenience only and the
Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and
contractors are cautioned to evaluate the requirements of this document based on the entire content
irrespective of the marginal notations and relationship to the last previous issue.
Referenced documents. In addition to MIL-DTL-28840, this document references the following:
ASTM A276
ASTM A473
ASTM A580/A580M
ASTM B26/B26M
ASTM B85/B85M
ASTM B108/B108M
ASTM B209
ASTM B211
ASTM B221
SAE-AMS2700
CONCLUDING MATERIAL
Custodians:
Preparing activity:
Army - AT
DLA - CC
Navy - EC
Air Force - 85
DLA - CC
(Project 5935-2013-101)
Review activities:
Army AV, MI
Navy - OS, SH, YD
Air Force 99
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the information
above using the ASSIST Online database at https://assist.dla.mil.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business