MIL-DTL-83413/4D
A nominal 7/16-inch hexagonal shaped plug body may be used in lieu of the cylindrical shape shown on
figure 1. If the hexagonal shaped body is used, knurling is not required and the .250 and .500
dimensions for positioning the knurling are not applicable.
Example of PIN: M83413/4-1
M
83413/ 4
-1
Dash number
Specification sheet number
General specification
Prefix
Certain provisions of this specification sheet are the subject of International Standardization Agreement
NATO STANAG 3632 and ISO 46. When amendment, revision or cancellation of this specification sheet
is proposed that will modify the international agreement concerned, the preparing activity will take
appropriate action through international agreement standardization channels, including departmental
standardization offices to change the agreement or make other appropriate accommodations.
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate
where changes from the previous issue were made. This was done as a convenience only and the
Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and
contractors are cautioned to evaluate the requirements of this document based on the entire content
irrespective of the marginal notations and relationship to the last previous issue.
Referenced documents. In addition to MIL-DTL-83413, this document references the following:
MIL-DLT-83413/5
MIL-DTL-83413/6
MIL-STD-1285
SAE-AMS2700
SAE-AMS-S-7720
NATO STANAG 3632
ISO 46
EIA-364-09
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business