MIL-DTL-83513/14D
Inches
mm
Inches
mm
Inches
mm
Inches
mm
.003
0.08
.050
1.27
.185
4.70
.450
11.44
.0038
0.097
.0671
1.704
.190
4.38
.660
16.76
.005
0.13
.096
2.44
.215
5.46
.984
25.00
.010
0.25
.130
3.30
.2282
5.80
1.215
30.86
.015
0.38
.144
3.66
.300
7.62
1.230
31.24
.025
0.64
.150
3.81
.360
9.14
1.435
36.45
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise specified, tolerances are .005 (0.13 mm).
4. Termination organization area to be optionally molded or filled with a potting fill material capable of passing the
electrical and environmental requirements of MIL-DTL-83513. Plastic molding shall conform to type GDI-30F or
type SDG-F in accordance with ASTM D5948 or GCT-30F in accordance with ASTM D5927 or MIL-M-24519 or
GST-40F in accordance with ASTM D4067 or MIL-M-24519 or GLCP-30F or GLCP-50 in accordance with
ASTM D5138 or MIL-M-24519.
5. Metal shell shall be of material in accordance with MIL-DTL-83513 for class M parts.
6. Jackpost (securely attached) when specified: Corrosion resistant steel in accordance with ASTM
A484/A484M and ASTM A582/A582M, 300 series stainless steel, passivated in accordance with SAE-
AMS-2700, type 2. Hardware will be attached in such a fashion as to not loosen during normal de-mating
conditions, where as, the mating connector hardware does not exceed the following torque values: 2.5
inch pounds for #2-56 (arrangements A G) and 4.5 inch pounds for #4-40 (arrangement H).
7. Separately molded plastic body (if used) shall conform to type GDI-30F or type SDG-F in accordance with
ASTM D5948 or GCT-30F in accordance with ASTM D5927 or MIL-M-24519 or GST-40F in accordance with
ASTM D4067 or MIL-M-24519 or GLCP-30F or GLCP-50 in accordance with ASTM D5138 or MIL-M-24519.
8. Wire termination sockets shall conform to A-A-59551, no. 24 AWG copper, except shall be tin-lead plated with
a minimum of 3 percent lead.
9. Interfacial seals are included with each type receptacle connector.
10. Termination lengths available: .109 (2.77 mm), .140 (3.56 mm), or .172 (4.37 mm). The tolerance shall be
.015 (0.38 mm) for all termination lengths.
11. Threaded insert, when specified: Corrosion resistant steel in accordance with ASTM A484/A484M and ASTM
A582/A582M, 300 series stainless steel, passivated in accordance with SAE-AMS-2700, type 2.
FIGURE 1. Connector, receptacle, .050 spacing - Continued.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business