MIL-STD-1532A(USAF)
1. SCOPE
1.1 ~cope. This standard covers insert arrangements for use with MIL-C-83733 rack to pane connectors, shell size B. It is used to control the dimensions and conflguratfon of fnsert patterns and the contact sizes.
2. REFERENCED DOCUMENT
2.1 Government document.
2.1.1 Specification. The following specification forms a part of this standard to the extent specified herein. Unless otherwise specified, the issue of this document shall be that listed in the issue of the Department of Defense Index of Specifications and Standards (OODISS) and supplement thereto, cited in the solicitation.
SPECIFICATION MILITARY
MIL-C-83733
Connectors, Electr1cal, Mfnfature, Rectangular Type, Rack to Panel, Environment Resisting, 200 C Total Continuous Operating Temperature, General Specification For.
(Copies of the specification required by contractors in connection with specific acquisition functions should be obtained from the contracting activity or as directed by the contracting activity.)
3. DEFINITIONS
3.1 Definitions. The terms used in this standard are generally accepted by the electrical and electronics industries and commonly used in electrical connector engineering practice.
4. GENERAL REQUIREMENTS: Not applicable.
5, DETAIL REQUIREMENTS
5,1 Dimensions. Dimensions shall be tn accordance with figure 1.
5.2 Marking. Marking shall be in accordance with MIL-C-83733 and as shown on figure 1.
* 5.3 Drawing notes. Unless otherwise specified, the following information is applicable to all figures of this military standard.
a. Dimensions are in inches.
b. Metric equivalents are given for general information only. c. Unless otherwise specified. tolerances are t.005.
6, NOTES
* 6.1 Subject term (key word} listing.
Connectors. rack to panel
Connectors. MIL-C-83733
Insert arrangements
6.2 Changes from previous issue. The margins of this standard are marked with asterisks to indicate where changes (addftfons, modifications, corrections, deletions) from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous Issue.
Source: https://assist.dla.mil -- Downloaded: 2014-09-28T11:11Z Check the source to verify that this is the current version before use.
1
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business