MS17348H
REQUIREMENTS:
Mates with plugs specified on MS17344 and covers specified on MS17349.
Class shall be designated by the letter C (pressurized), J (pressurized with grommet) or R (environmental resisting).
For shell size, insert arrangement, alternate position, contact size, spacing and service rating, see
MIL-STD-1651.
Shell finish: See MIL-DTL-22992.
Safety wire shall not pull out of safety wire holes when safety wire NI-CU alloy (monel TM) (UNS N04400) or NI-CR alloy (inconel TM) (UNS N06600), .020 inches (0.51 mm) diameter and in accordance with NASM20995, is threaded through a hole and a pull of 30 lbs (13.61kg) minimum is applied. Two pulls shall be made, one parallel with axis of nut and one perpendicular to axis of nut.
Class shall be designated by the letter C (pressurized), J (pressurized with grommet) or R (environmental resisting).
Part or Identifying Number (PIN) example.
MS17348 R 20 C 27 P W
MS number
Class Shell size Finish
Insert arrangement Contact style Alternate position
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.
Referenced documents. In addition to MIL-DTL-22992, this document references the following.
MS17344
MS17349
MIL-STD-1651
NASM20995
SAE-AS29513
6
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business