INCH-POUND
MIL-DTL-24231/24E(SH)
26 April 2013
SUPERSEDING
MIL-C-24231/24D(SH)
15 May 1987
DETAIL SPECIFICATION SHEET
CONNECTOR, SINGLE CABLE, TYPE III, THREE-CONDUCTOR, FOR LSTHOF-9 CABLE
This specification is approved for use by the Naval Sea Systems Command and is available for use by all
Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-24231.
REQUIREMENTS:
2. Pin contact shall be Amphenol Corporation, Size 12, solder type, part number 10-33646, with silver plate
followed by gold plate not less than 0.0001 thick; or equal. Any other pin contact submitted as equal shall be
subject to review by NAVSEA.
3. All dimensions are in inches.
4. Tolerances shall be as follows, or as stated:
Decimals ±0.005 inch.
a.
Fractions ±1/64 inch.
b.
Angular dimensions ±½ degree.
c.
5. The gland nut shall be tightened until the packing tightens against the wires and cables. This can be
determined by moving the wires and cables gently back and forth until the wire and cable is seized by the packing.
The gland nut shall be turned approximately one-fourth of a turn more to hold wires and cables in place. Do not
overtighten the gland nut or attempt to tighten down metal to metal, as this can damage the wires and cables.
AMSC N/A
FSC 5935
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business