INCH-POUND
MIL-DTL-24231/8E(SH)
26 April 2013
SUPERSEDING
MIL-C-24231/8D(SH)
15 May 1987
DETAIL SPECIFICATION SHEET
CONNECTORS, SINGLE CABLE, TYPE III, SEVEN-CONDUCTOR
This specification is approved for use by the Naval Sea Systems Command and is available for use by all
Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-24231.
REQUIREMENTS:
2. Refer to MIL-DTL-24231/5 for alternate method of manufacturing connector body and installing guide pin
M24231/5-071.
3. For welding of the pin, item 20, see MIL-DTL-24231/5.
4. Full or partial threads shall not extend more than 0.083 inch beyond the 11/16-inch thread length.
5. All dimensions are in inches.
6. Tolerances shall be as follows, or as stated:
Decimals ±0.005 inch.
a.
Fractions ±1/64 inch.
b.
Angular dimensions ±½ degree.
c.
7. The flange outside diameter is intended to coincide with commonly available 2¾-inch bar stock. The
dimension may vary after machine clean-up.
8. The gland nut shall be tightened until the packing tightens against the wires and cables. This can be
determined by moving the wires and cables gently back and forth until the wire and cable is seized by the packing.
The gland nut shall be turned approximately one-fourth of a turn more to hold wires and cables in place. Do not
overtighten the gland nut or attempt to tighten down metal to metal, as this can damage the wires and cables.
AMSC N/A
FSC 5935
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business