MIL-DTL-83734/17A
Inches
mm
Inches
mm
4.57
.180
0.08
.003
4.78
.188
0.20
.008
5.08
.200
0.25
.010
7.37
.290
1.02
.040
9.91
.390
1.27
.050
10.16
.400
2.11
.083
12.10
.480
2.24
.088
12.70
.500
2.48
.098
15.24
.600
2.54
.100
17.78
.700
3.18
.125
22.86
.900
3.81
.150
40.64
1.600
4.52
.178
58.42
2.300
Dash number
Dimension "A" max/min
Dimension "B" max
(mm)
(mm)
-001, 002, 003
.210/.190 (5.33/4.83)
.470 (11.90)
-004, 005, 006
.210/.190 (5.33/4.83)
.565 (14.30)
-007, 008, 009
.210/.190 (5.33/4.83)
.715 (18.20)
-013, 014, 015
.175/.155 (4.44/3.94)
.300 (7.62)
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified tolerances are ±..005 inch (0.13 mm) for three place decimals.
4. Holes to be provided for mounting. A recess to be provided to fully enclose the head or nut of the fastener below the surface
of the sockets.
5. Devices shall accept flat leads .008 inch (0.20 mm) to .015 inch (0.38 mm) thick by .015 inch (0.38 mm) to .021 inch (0.53 mm)
wide. The values for mating forces are based upon the use of standard leads .011 ±.002 inch (0.28 ±0.05 mm) thick by .018
±.002 inch ( 0.46 ±0.05 mm) wide. The length of the lead accepted by the device shall be .150 inch (3.81 mm) long for the low
profile sockets. Contact shall be made at or before reaching a depth of .100 inch (2.54 mm) in the low profile socket.
6. A visual polarization index shall be provided in the first quadrant. If the visual index overlaps into the fourth quadrant, it shall
be adjacent to or clockwise from contact number one.
7. It is desirable that the socket face shall be relieved to facilitate removal of the integrated circuit.
FIGURE 1. Dimensions and configurations - Continued.
2