MIL-PRF-39012/67C
TABLE V. Group qualification and retention testing.
Group
Submission and retention of
Qualifies the following
Qualification of any of the
connectors
following connectors 1/
M39012/
M39012/
I
67-0003
67-0003
67-0103 2/
II
67-0004
67-0004
67-0104 2/
III
67B0008
67B0008
67B0013 2/
IV
67B0009
67B0009
67B0010
67B0014 2/
67B0015 2/
V
67B0010
67B0010
67B0015 2/
VI
67-0011
67-0011
67-0016 2/
VII
67-0012
67-0012
67-0017 2/
1/ For qualification retention, where more than one part is listed in a group in this column, data may be
supplied on any of those parts in order to retain qualification for those parts in the corresponding right
hand column.
2/ Corrosion and contact resistance test data must be submitted to DSCC-VQ before qualification
approval may be granted.
NOTE: If a connector manufacturer produces a connector which meets all the requirements for two or
more connector PINs (within the same series), the manufacturer may receive qualification approval for
two or more connector PINs by qualifying the one connector. It is not necessary that such connectors be
in the same group. Each connector, however, must be marked with its own appropriate PIN. For group
qualification, the connectors must be of similar design. Qualification of connectors qualifies connectors of
the same material and finish only.
11
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business