MIL-DTL-12883/47D
TABLE IV. Torque requirements (installed in panel conditions).
Torque
Thread
Testing
Installation
size
Inch-
Newton
Inch-
Newton
pounds
pounds
8
0.90
.112-40
4 ±1
0.54 ± .11
+1
+ .11
-0
-0
2.71
24
.190-32
18 ±1
2.03 ± .11
+ .11
+1
-0
-0
Weight: .176 pound (80 grams) maximum weight of relay socket, all contacts and associated hardware.
PIN: The PIN shall be marked on the socket body as shown in the example (see figure 1). The PIN
shall consist of the basic number of this specification sheet and the dash number from table I.
Example:
*
-01
S
M12883/47
Basic document number
Dash number
Modifier S shall be used in the
PIN only when ordering sockets
furnished with corrosion resistant
steel hardware with no finish.
* For future acquisition of these sockets as of the effective date of revision D, 20 December 1989, parts
with an "S" modifier shall be corrosion resisting steel (CRS), and parts without an "S" modifier shall be
cadmium chromate finish. No mixing.
Ordering data: Sockets without contacts may be ordered when so indicated (see MIL-DTL-12883). This
applies only to the original equipment manufacturers (OEM's) and subcontractors. All direct shipments
to the government shall include all applicable contacts and mounting hardware. The PIN to be marked
on the socket shall be as shown in the PIN example.
The Government PIN, specified in table V, supersedes the following commercial PINs.
10
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business