MIL-DTL-12883F
APPENDIX
TEST GAUGES FOR SOCKETS
10. SCOPE
10.1 Scope. This appendix details the test gauges to be used in the test procedures on sockets covered by this
specification. Where particular designs of gauges for specific tests are not established, indication is made for the use
of satisfactory test-gauge substitute. This appendix is a mandatory part of the specification. The information
contained herein is intended for compliance.
10.2 Gauges.
10.2.1 Identification of gauges. Gauges are identified by means of a descriptive title that indicates the associated
test (see figures 1 to 5, inclusive). Additionally, the gauges are identified herein, in regard to their selected use with
particular sockets, by means of a contact arrangement applicable to the socket design. The essential contact
arrangement is depicted in the applicable specification sheet for the respective socket.
10.2.2 Supply of gauges. The laboratory or activity that performs the tests will be responsible for supply of all
necessary test fixtures and gauges.
20. APPLICABLE DOCUMENTS
20.1 Non-Government publication. The following document forms a part of this document to the extent specified
herein. Unless otherwise specified, the issues of the documents which are DoD adopted are those listed the issue of
the DODISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in the DODISS
are the issues of the document cited in the solicitation (see 6.2).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI B46.1
-
Surface Texture (Surface Roughness, Waviness and Lay).
(Application for copies should be addressed to the American National Standards Institute, 11 West 42nd Street,
New York, NY 10036.)
AMERICAN SOCIETY OF TESTING MATERIALS
ASTM B16
-
Rod, Bar, and Shapes for use in Screw Machines, Free Cutting Brass.
(Application for copies should be addressed to the American Society for Testing and Materials, 1916 Race Street,
Philadelphia, PA 19103.)
SOCIETY OF AUTOMOTIVE ENGINEERS (SAE)
SAE AMS 4120
-
Aluminum Alloy, Rolled or Cold Finished Bars, Rods, and Wire, 4.4Cu 1.5Mg 0.60Mn
(2024), Solution Heat Treated and Naturally Aged (T4), Solution Heat Treated, Cold
Worked, and Naturally Aged (T351).
SAE J438
-
Tool and Die Steels.
(Application for copies should be addressed to the Society of Automotive Engineers, 400 Commonwealth Drive,
Warrendale, PA 15096-0001.)
(Non-Government standards and other publications are normally available from the organizations that prepare or
distribute the documents. These documents also may be available in or through libraries or other informational
services.)
20.2 Order of precedence. In the event of a conflict between the text of this appendix and the references cited
herein, the text of this appendix shall take precedence.
25
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business