For Parts Inquiries call (727) 344-9615
A Service Disabled Veteran Owned Small Business
© Copyright 2015 Integrated Publishing, Inc.

MIL-DTL-12883 Sockets And Accessories For Plug-In Electronic Components, General Specification ForThis specification covers the general requirements for sockets and socket accessories for plug-in electronic components, such as electron tubes and related electronic devices, plug-in capacitors, crystal units, batteries, vibrators, relays, transistors, coils, etc. \(see 6.2\).

Pages 1 - - 8|||9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26|||


MIL-DTL-12883F
4.7.3 Insulation resistance (see 3.5.2). Sockets shall be tested in accordance with method 3003, of
MIL-STD-1344. The following details and exceptions shall apply:
a. Mounting: Mounted on a .125 inch (3.17 mm) metal plate; a pin of the specified diameter (see 3.1),
shall be placed in each contact. No soldering to the contact tabs shall be allowed.
b. Points of measurements:
(1)
Connect all odd-numbered contacts together.
(2)
Connect all even-numbered contacts together.
(3)
Measure between the odd-numbered contacts (tied together) and the even-numbered
contacts (tied together).
c.
After testing sockets shall meet the requirements of 3.5.2.
d. Points of measurements:
(1)
Connect all contacts together.
(2)
Connect all metallic parts (except contacts) of the socket together.
(3)
Measure between all contacts (tied together), and the metallic parts of the socket (tied
together), with the positive test probe on the contacts.
e. After testing sockets shall meet the requirements of 3.5.2.
4.7.4 Dielectric withstanding voltage (see 3.5.3). Sockets shall be tested in accordance with method
3001 of MIL-STD-1344.
4.7.4.1 Sea level (normal atmospheric pressure). Sockets shall be tested as specified in 4.7.4. The
following details and exceptions shall apply:
a. Mounting: Mounted on a .125 inch (3.17 mm) metal plate; a pin of the specified diameter (see 3.1),
shall be placed in each contact and held there by means of a pin-holding device. No soldering to
the contact tabs shall be allowed.
b. Magnitude and nature of test voltage: As specified (see 3.1).
c.
Duration of application of test voltage: 60 seconds.
d. Points of application:
(1)
Connect all odd-numbered contacts together.
(2)
Connect all even-numbered contacts together.
(3)
Measure between the odd-numbered contacts (tied together) and the even-numbered
contacts (tied together).
e. After testing sockets shall meet the requirements of 3.5.3.
17



For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business

© Copyright 2015 Integrated Publishing, Inc. Site Design & Marketing by Strategico.