INCH-POUND
MIL-DTL-24231/19E(SH)
26 April 2013
SUPERSEDING
MIL-C-24231/19D(SH)
15 May 1987
DETAIL SPECIFICATION SHEET
CONNECTOR, SINGLE CABLE, TYPE III, 65-CONDUCTOR
This specification is approved for use by the Naval Sea Systems Command and is available for use by all
Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-24231.
REQUIREMENTS:
2. The gland nut shall be tightened until the packing tightens against the wires. This can be determined by
moving the wires gently back and forth until the wire is seized by the packing. The gland nut shall be turned
approximately one-fourth of a turn more to hold the wires in place. Do not overtighten the gland nut or attempt to
tighten down metal to metal, as this can damage the wires.
3. Refer to MIL-DTL-24231/5 for alternate method of manufacturing connector body and installing guide pin
M24231/5-071.
4. Welding of the pin is allowed after the hull fitting body has been age-hardened to achieve its required
physical properties.
5. The retainer plates and retainer plate assemblies shall be manufactured from nickel-copper alloy in
accordance with Class A, Form 1, hot-finished condition of QQ-N-281 with a minimum yield strength of
40,000 lbf/in2 at 0.2 percent offset, or nickel-copper alloy in accordance with Class A, Form 1, cold-drawn condition
of QQ-N-281 with a minimum yield strength of 50,000 lbf/in2 at 0.2 percent offset.
6. All dimensions are in inches.
7. Tolerances shall be as follows, or as stated:
Decimals ±0.005 inch.
a.
Fractions ±1/64 inch.
b.
Angular dimensions ±½ degree.
c.
8. These connectors are for maintenance purposes only.
AMSC N/A
FSC 5935
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business