INCH-POUND
MIL-DTL-24231/26E(SH)
26 April 2013
SUPERSEDING
MIL-C-24231/26D(SH)
15 May 1987
DETAIL SPECIFICATION SHEET
CONNECTOR, SINGLE CABLE, TYPE III, FOR TYPE 2SWF CABLES
This specification is approved for use by the Naval Sea Systems Command and is available for use by all
Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-24231.
REQUIREMENTS:
2. Where a standard gland assembly (Type J in accordance with MIL-DTL-24231/11) is used, any unused
holes in retainer plates and packing shall be plugged with cable Type LS2SWU-1 in accordance with
MIL-DTL-24231/11.
3. Cable shall be marked with pin circuit identification numbers at the exposed ends.
4. Cables shall be protected after installation by a method approved by the contracting activity.
5. The gland nut shall be tightened until the packing tightens against the cables. This can be determined by
moving the cables gently back and forth until the cable is seized by the packing. The gland nut shall be turned
approximately one-fourth of a turn more to hold cables in place. Do not overtighten the gland nut or attempt to
tighten down metal to metal, as this can damage the cables.
6. Unless otherwise specified (see figure 2), all dimensions are in inches.
7. Tolerances shall be as follows, or as stated:
Decimals ±0.005 inch.
a.
Fractions ±1/64 inch.
b.
Angular dimensions ±½ degree.
c.
AMSC N/A
FSC 5935
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business