MIL-DTL-39024/11G
TABLE I. Design and identification data Continued.
1/ Dimensions are in inches. Metric equivalents are given for information only.
2/ Dash numbers -21 through -30 have been deleted. See Table II for recommended substitutes.
Dash numbers -51 through -70 have been canceled without replacement.
3/ X = G For parts with gold plated terminals. (OEMs may order parts with gold plated
terminals, marked with the suffix "G", and request that the terminals be solder
dipped as a post manufacturing operation.) X = blank for parts with any of the specified terminal
finishes. (OEMs may identify a specific terminal finish in their purchase order.)
4/ Dash numbers -01X through -10X are for use by OEMs. When a qualified products list source is
available for dash number -71X through -80X, only they will be acquired by the government for stock
and issue in place of dash numbers -01X through -10X, respectively.
5/ Clinchable terminals. See terminal bendability requirements.
REQUIREMENTS:
Design and construction:
Dimensions and configuration: See figure 1 and table I.
Insulation: Material shall be polyamide in accordance with L-P-410 or ASTM D4066.
Test probe: 0.080 ± 0.001 inch (2.03 ± 0.03 mm ) in diameter (connector shall accept test probe from
either end). Test probe shall be engaged a minimum of .450 inches. Test probe shall be fully inserted.
Insulation resistance: Test circuit figure in MIL-DTL-39024 shall be used.
Dielectric withstanding voltage (at sea level): Test circuit figure in MIL-DTL-39024 shall be used.
The applicable voltage shall be applied for 15 seconds.
For -01X through -10X, 2000 volts rms, 60Hz, -41X through -50X, 500 volts rms, 60Hz, -71X through -
80X, 2000 volts rms, 60 Hz.
Insulation and withdrawal forces
Insertion force: 5.0 pounds (maximum)
Withdrawal force: 0.5 pounds (minimum)
Terminal bendability: for -71X through -80X, when the part is seated on a .0625 inch (1.588mm) nominal
thickness printed wiring board there shall be no breakage or visible fracture of the terminals when they are
clinched parallel to the board surface.
Identification marking:
The marking shall be located on the immediate container.
Part or Identifying Number (PIN): M39024/11-(dash number from table I). G on parts furnished to the
government. The suffix "G" shall be used to identify parts with gold plated terminals. OEMs may order
parts with or without gold plated terminals and mark them according to footnote 3 in table I. Effective
date of this revision, all parts furnished to the government for stock and issue shall have gold plated
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business