MIL-DTL-55302/102E
Mounting screw: Brass, cadmium plated, gold chromate finish.
Flat washer: Stainless steel.
Contact identification: Contact locations are identified in numerical sequence (see figure 1).
Mating and unmating: The maximum insertion force in pounds, shall not exceed a value equal to .5
times the number of contacts, and the withdrawal force, in pounds shall be a minimum of .11 times the
number of contacts and shall not exceed the measured insertion force.
Contact retention: 6.0 pounds minimum after 5 insertions and withdrawals from the same connector.
Contact resistance: The contact resistance shall not exceed 20 milliohms.
Dry circuit: Connectors shall be tested in accordance with test procedure EIA-364-23. The contact
resistance shall not exceed 20 milliohms.
Dielectric withstanding voltage:
Sea level: 1,000 volts rms, 60 hertz.
High altitude: 300 volts rms, 60 hertz.
Current rating, maximum: 5 amperes.
Keying : When required, one of the following codes shall be added to the dash number:
"P" Specifying location by contact number where keying pin shall be inserted; for example,
M55302/102-01P17. (Keying pin inserted in place of contact number 17.)
"H" Specifying location by contact number where contact shall be omitted for mating; for example,
M55302/102-01H17. (Keying pin hole has contact number 17 omitted.)
Contact crimp removable (Class A or B): Shall conform to MIL-DTL-55302/97.
Contact removal tool: Shall conform to MIL-I-81969/4.
Contact insertion tool: Shall conform to MIL-I-81969/5.
Contract crimp tool: Shall conform to M22520/17-02.
Mating plug: Shall conform to MIL-DTL-55302/53 and MIL-DTL-55302/54.
PIN: M55302/102-(dash number from table I).
Changes from previous issue. Marginal notations are not used in this revision to identify changes with
respect to the previous issue due to the extent of the changes.
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business