MIL-PRF-39012/75C
TABLE V. Group qualification and retention testing.
Group
Submission and retention of
Qualifies the following
qualification of any of the
connectors
following connectors 1/
M39012/
M39012/
I
75-0003
75-0003
75-0103 2/
II
75-0004
75-0004
75-0104 2/
III
75B0008
75B0008
75B0014 2/
IV
75B0009
75B0009
75B0010
75B0015 2/
75B0016 2/
V
75B0010
75B0010
75B0016 2/
VI
75-0011
75-0011
75-0017 2/
VII
75-0012
75-0012
75-0018 2/
VIII
75-0013
75-0013
IX
75-0105
75-0105
1/ For qualification retention, where more than one part is listed in a group in this column, data may be
supplied on any of those parts in order to retain qualification for those parts in the corresponding right
hand column.
2/ Corrosion and contact resistance test data must be submitted to DSCC-VQ before qualification
approval may be granted.
NOTE: If a connector manufacturer produces a connector which meets all the requirements for two or
more connector PINs (within the same series), the manufacturer may receive qualification approval for
two or more connector PINs by qualifying the one connector. It is not necessary that such connectors be
in the same group. Each connector, however, must be marked with its own appropriate PIN. For group
qualification, the connectors must be of similar design. Qualification of connectors qualifies connectors of
the same material and finish only.
10
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business