MS27741A
Requirements:
Design and construction: See figures 1, 2, and 3. Material:
a. Body: Aluminum alloy in accordance with SAE-AMS-QQ-A-225 and ASTM B211. b. Nut: Aluminum alloy in accordance with SAE-AMS-QQ-A-225 and ASTM B211.
c. Spring: Copper alloy
d. Friction washer: Teflon.
Finish:
a. Body: Gold iridite in accordance with MIL-C-5541. b. Nut: Gold iridite in accordance with MIL-C-5541.
Shield compensation: Captivated spring member in clamp nut compensates for differences in shield thickness of at least 0.020 inch (.508 mm) between adjacent slots in body.
Shield accommodation: Each slot in body will accommodate up to .180 inch (4.572 mm) total shield thickness.
Ground lead pullout. Retention of ground leads shall meet the requirements of SAE-AS21608. Items described in this drawing are covered by US Patent No 3,465,092.
Illustrations copyrighted by Glenair, Inc 1968. However, the US Government has been granted, in writing by Glenair Inc, the continued rights to use this copyrighted material.
Assembly instructions:
The following instructions are suggested assembly procedures only. Actual termination and assembly method will depend on the accepted techniques of the user. The TAG ring requires no special assembly tools and can be assembled by hand. However, the user may find it preferable to use soft jaw pliers for final tightening of the TAG rings.
In all cases, a self-pigtailing technique for the individual shields is used, with the point at which the conductors are extracted through the shields to be determined by the particular connector involved. For solder contact connectors, the length of the extracted conductor will be shorter than for crimp contact connectors. It is suggested that all shield pigtails be flattened before installing the TAG ring.
TAG Ring:
a. Place TAG ring on wire bundle or cable with castellated (slotted) face of body toward termination end of cable (see figure 2, step 1).
b. If shielded conductors have an outer jacket, strip jacket to desired length. Extract conductors through shields at location desired for installation of TAG ring. Flatten shield pigtails.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business