MS27741A
Step 4
f. Fold shields over knurled surface of body and engage clamp nut aligning tabs of clamp nut spring with slots in body. Tighten securely as shown in step 4. Hand tightening can be used, but if preferred, soft jaw pliers can be used for final tightening.
Step 5
g. Trim excess shields to desired length, either flush with surface of TAG ring or to any length desired. For future reparability, it is suggested at least .5 inch (12.7 mm) shield lengths be retained (see step 5).
Step 6
h. If desired, safety wire can be installed through hole provided in clamp nut. Simply loop wire through hole and tighten as shown in step 6. With safety wire installed between two body tabs, it works similar to a cotter pin to prevent accidental loosening.
FIGURE 2. Assembly instructions - Continued.
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business