INCH-POUND
MIL-DTL-25516F
4 November 2004
SUPERSEDING
MIL-DTL-25516E
22 August 2000
DETAIL SPECIFICATION
CONNECTORS, ELECTRICAL, MINIATURE, COAXIAL, ENVIRONMENT RESISTANT TYPE,
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers a series of miniature, moisture proof connectors suitable for
operation with shielded and unshielded cable up to 750 volts rms under severe environmental conditions.
1.2 Classification. Connectors covered by this specification will be of the following series, classes, and
types, as specified (see 3.1).
Series I -
Plugs and receptacles, cable termination.
Series II -
Plugs and receptacles, permanent crimp, (using a standard MIL-DTL-22520 tool).
Series III -
Adapters, all types.
Series IV -
Plugs and receptacles, solder termination.
Class G -
General purpose.
Class H -
Hermetic, sealed cable termination.
Class Y -
Hermetic, adapters.
Type 1 -
Shield termination, continuous circuit, grounded.
Type 2 -
Shield termination, continuous circuit, isolated ground.
Type 3 -
Shield termination, interrupted ground.
Type 4 -
No shield termination.
Type 5 -
Class Y, grounded outer circuit.
Type 6 -
Class Y, ungrounded outer circuit.
Comments, suggestions, or questions on this document should be addressed to: Commander,
Defense Supply Center Columbus, Attn: VAI, P.O. Box 3990, Columbus, Ohio 43218-3990 or emailed
to RFConnectors@dscc.dla.mil. Since contact information can change, you may want to verify the
currency of this address information using the ASSIST Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5935
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business