MIL-DTL-641F
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-1916
-
DoD Preferred Methods for Acceptance of Product.
MIL-STD-202
-
Test Methods for Electronic and Electrical Component Parts.
MIL-STD-464
-
Electromagnetic Environmental Effects Requirements for Systems
MIL-STD-1285
-
Marking of Electrical and Electronic Parts.
MIL-STD-1353
-
Electrical Connectors and Hardware.
(Copies of these documents are available online at https://quicksearch.dla.mil/ or from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract
(see 6.2).
ASME INTERNATIONAL
ASME B107.100-2010- Socket Wrenches, Handles, and Attachments.
(Copies of these documents are available online at https://www.asme.org or from the ASME International, Three
Park Avenue, New York, NY 10016-5990.)
ELECTRONIC COMPONENTS INDUSTRY ASSOCIATION (ECIA)
EIA364
-
Electrical Connector/Socket Test Procedures including Environmental Classifications.
(Copies of these documents are available online at https://eciaonline.org or from the Electronic Components
Industry Association (ECIA), 1111 Alderman Dr., Suite 400, Alpharetta, GA 30005-4175.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited
herein (except for specification sheets), the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exception has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with
the applicable specification sheets. In the event of conflict between requirements of this specification and the
specification sheet, the latter shall govern.
3.2 Classification of requirements. The requirements for the jacks are classified herein as follows:
Requirement
Paragraph
Qualification - - - - - - - - - -
Materials- - - - - - - - - - - - -
Design and construction- -
Performance- - - - - - - - - -
3.3 Qualification. Jacks furnished under this specification shall be products which are qualified for listing on the
applicable qualified products list at the time set for opening of bids (see 4.4 and 6.4).
3.4 Materials. The materials shall be as specified herein. However, when a definite material is not specified, a
material shall be used which enable the jacks to meet the performance requirements of this specification.
Acceptance or approval of any constituent material shall not be construed as a guaranty of the acceptance of the
finished product.
3.4.1 Fungus-inert. Materials used in the construction of these jacks shall be fungus-inert (see requirement 4
of MIL-STD-464).
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business