MIL-DTL-83517A
TABLE II. Qualification inspection continued.
1/ See 3.1.
2/ These tests to be performed only during initial qualification as long as the
qualifying design and manufacturing process has not been changed.
TABLE III. Group A inspection. 1/
Inspection
Requirement
Test method
Sampling
paragraph
paragraph
procedure
Visual and mechanical inspection
Material
Finish
Dissimilar metals
Design and construction
See table IV
Marking
Workmanship
Seal 2/
Hermetic seal connectors
Pressurized and waterproof
Dielectric withstanding voltage
1/ Verification may be accomplished using the manufacturer's process controls providing these
controls are clearly equal to or more stringent than the requirements of this specification.
2/ These are in-process tests (100% inspection required).
4.4.1.2.2 Visual inspection (group A inspection). Each connector shall be visually examined for
completeness, workmanship, and identification requirements. Attention shall be given to those
assemblies that require a gasket to determine the condition of the gasket. Gaskets missing, twisted,
buckled, kinked, or damaged in any way shall be cause for rejection.
TABLE IV. Group A sampling plan.
Visual and mechanical inspection
Lot size
All
1
to
19
20
20
to
280
47
281
to
1,200
53
1,201
to
3,200
68
3,201
to
10,000
77
10,001
to
35,000
35,001
to
150,000
96
150,001
to
500,000
119
500,001
to
over
143
4.4.1.3 Group B inspection. Group B inspection shall consist of the inspections specified in table V in
the order shown, and shall be made on sample units which have been subjected to and passed the group
A inspection. Connectors having identical piece parts may be combined for lot purposes and shall be in
proportion to the quantity of each PIN numbered connector produced.
11
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business