MIL-DTL-83517A
3.19 Thermal shock. After testing as specified in 4.5.16, there shall be no visual evidence of
mechanical damage to the connector and it shall meet the dielectric withstanding voltage requirement
(see 3.12). The contact resistance specified for the center contact shall not be exceeded (see 3.18), and
the connector shall meet the VSWR requirements (see 3.14).
3.20 Moisture resistance. When connectors are tested as specified in 4.5.17, there shall be no
evidence of damage. They shall withstand the dielectric withstanding voltage specified (see 3.12), and
3.21 Radio frequency (RF) high potential withstanding voltage. When connectors are tested as
3.22 Coupling mechanism retention force. When tested as specified in 4.5.19, the coupling
mechanism shall not be dislodged from the connector and shall meet the requirements of 3.5 immediately
after the test (see 3.1).
3.23 Marking. Connectors and associated fittings shall be permanently and legibly marked in
accordance with the general marking requirements of MIL-STD-130 with the military part number (see
1.2.1), manufacturer's federal supply code and final assembly date code. The marking location is
optional. When practicable, a location should be picked that will least likely be covered when installed
(see 4.5.1 ).
3.23.1 JAN and J marking. The United States Government has adopted, and is exercising legitimate
control over the certification marks "JAN" and "J", respectively, to indicate that items so marked or
identified are manufactured to, and meet all the requirements of specifications. Accordingly, items
acquired to, and meeting all of the criteria specified herein and in applicable specifications shall bear the
certification mark "JAN" except that items too small to bear the certification mark "JAN" shall bear the
letter "J". The "JAN" or "J" shall be placed immediately before the part number except that if such location
would place a hardship on the manufacturer in connection with such marking, the "JAN" or "J" may be
located on the first line above or below the part number. Items furnished under contracts or orders which
either permit or require deviation from the conditions or requirements specified herein or in applicable
specifications shall not bear "JAN" or "J". In the event an item fails to meet the requirements of this
specification and the applicable specification sheets, the manufacturer shall remove completely the
military part number and the "JAN" or the "J" from the sample tested and also from all items represented
by the sample. The "JAN" and "J" certification mark shall not be used on products acquired to contractor
drawings or specifications. The United States Government has obtained Certificate of Registration
Number 504,860 for the certification mark "JAN" and Registration Number 1,586,261 for the certification
mark "J".
3.24 Workmanship. Connectors and associated fittings shall be processed in such a manner as to be
uniform in quality and shall be free from sharp edges, burrs, and other defects that will affect life,
serviceability or appearance.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as
follows:
a. Qualification inspection (see 4.3).
b. Conformance inspection (see 4.4).
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business