MIL-DTL-83517A
INSTITUTE OF ELECTRICAL AND ELECTRONICS ENGINEERS, INC.
IEEE-287
-
Precision Coaxial Connector
(Copies of these documents are available online from https://www.corporate-communications@ieee.org or
from the IEEE Operations Center, 445 Hoes Lane, Piscataway, New Jersey 08854-1331.)
SOCIETY OF AUTOMOTIVE ENGINEERS, INC (SAE)
SAE-AMS-QQ-N-290
-
Nickel Plating (Electrodeposited).
SAE-AMS-QQ-S-763
-
Steel Bars, Wire, Shapes, and Forgings; Corrosion Resistant.
SAE-AMS2700
-
Passivation of Corrosion Resistant Steel.
(Copies of these documents are available online from https://www.sae.org or from the Society of
Automotive Engineers, 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related specification sheets), the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheet. In the event of any conflict between the requirements
of this specification and the specification sheet, the latter shall govern.
3.2 Qualification. Connectors furnished under this specification shall be products that are authorized
by the qualifying activity for listing on the applicable qualified products list before contract award (see 4.3
and 6.4).
3.2.1 Product assurance requirements. The product assurance requirements of the connector
sources furnished under this specification shall be established and maintained in accordance with the
procedures and requirements specified in MIL-STD-790 (or equivalent with the Qualifying activities
approval) with details specified in 4.1.2.
3.3 Material. Material shall be as specified herein (see table I). If materials other than those specified
are used, the contractor shall certify to the qualifying activity that the substitute material enables the
connectors to meet the requirements of this specification. Acceptance or approval of any constituent
material shall not be construed as a guaranty of the acceptance of the product. When a definite material
is not specified, a material shall be used which will enable the connector to meet the requirements of this
specification.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business