MIL-PRF-39012/17H
REQUIREMENTS
Designs and configurations: See figures 1, 2, 3, and 4.
Force to engage and disengage:
Longitudinal force - 3 pounds (13.34 N) maximum.
Torque 2.5 inch-pounds (.28 Nm), maximum.
Coupling proof torque: Not applicable.
Inspection conditions: Coupling torque not applicable.
Mating characteristics:
In accordance with MIL-STD-348 and figure 2 for dimensions.
Center contact (socket):
Oversize test pin: .057 inch (1.45 mm) diameter minimum (nonclosed entry contacts only).
Insertion depth: .125 inch (3.17 mm) minimum.
Number of insertions: 1.
Insertion force test: Steel test pin diameter .054 inch (1.37 mm) minimum.
Test pin finish: 16 microinches (4.437 kPa).
Insertion force: 2 pounds (8.90 N), maximum.
Withdrawal force test: Steel test pin diameter .052 inch (1.32 mm), maximum.
Withdrawal force: 2 ounces (.56 N), minimum.
Test pin finish: 16 microinches (0.406 µm).
Hermetic seal: Not applicable.
Leakage (pressurized connectors): Not applicable.
Insulation resistance: Method 302 of MIL-STD-202, test condition B. 5,000 megohms minimum.
Center contact retention: 6 pounds (26.69 N) minimum axial force. Applicable to captivated-center-
contact connectors only.
Corrosion (salt spray): Method 101 of MIL-STD-202, test condition B.
Voltage standing wave ratio (VSWR): From 500 to 4 GHz, or approximately 80 percent of upper
cutoff frequency of the cable, whichever is lower; 1.30 maximum.
9
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business