MIL-STD-16328
5. DETAIL REQUIREMENTS
5.1 Dimensions. Dimensions shall be in accordance with the applicable section of this standard and the following dimensional data:
a. Dimensioning and tolerancing in accordance with ASME-Y14.5. Dimensions are true postion and are inches.
b. Metric equivalents are given for information only and are based on 1 inch equals 25.4 mm.
c. Dimensions and markings shown are for engaging face of pin insert; socket inserts are mirror image.
d. Contact holes in insert shall be located on TP (true position) within .005 inch (0.13 mm)
diameter circle.
e. Tolerances are ±.010 for three place decimals, ±.030 for two place decimals and ± 0° 30' for angles.
f. Polarization shall be in accordance with MIL-DTL-28804.
5.2. Contacts. Contacts shall be in accordance with MIL-DTL-28804/9 and MIL-DTL-28804/10 or the applicable connector specification sheet.
5.3 Marking. Marking shall be in accordance with MIL-DTL-28804 and as shown in the applicable section of the standard.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Subject term (key word) listing.
Contact sizes
Insert pattern
6.2 Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business