INCH-POUND
MIL-DTL-24231/3E(SH)
26 April 2013
SUPERSEDING
MIL-C-24231/3D(SH)
15 May 1987
DETAIL SPECIFICATION SHEET
CONNECTOR, PLUG, TYPE I, MOLDED, SEVEN- AND NINE-CONDUCTOR
(STRAIGHT AND 90 DEGREES)
This specification is approved for use by the Naval Sea Systems Command and is available for use by all
Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-24231.
REQUIREMENTS:
2. For termination of cable shield, see table for cable types for molded plugs in MIL-DTL-24231.
3. Sleeve M24231/3-010 may be modified prior to assembly by drilling or slotting to allow cable entry from the
side. Sharp edges shall be rounded.
4. Ni-Cu plug sleeves shall be coated with plasma spray non-conductive material in accordance with
S9320-AM-PRO-030/MLDG.
5. All dimensions are in inches.
6. Tolerances shall be as follows, or as stated:
Decimals ±0.005 inch.
a.
Fractions ±1/64 inch.
b.
Angular dimensions ±½ degree.
c.
AMSC N/A
FSC 5935
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business