MIL-DTL-25516F
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the
contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor
personnel, these personnel need to contact the responsible packaging activity to ascertain packaging
requirements. Packaging requirements are maintained by the Inventory Control Point's packaging
activities within the Military Service or Defense Agency, or within the Military Service's System Command.
Packaging data retrieval is available from the managing Military Department's or Defense Agency's
automated packaging files, CD-ROM products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. The miniature coaxial connectors covered by this specification are intended primarily
for use in capacitance-type fuel-quantity-measurement systems in all types of aircraft and missiles at the
lower frequencies. These connectors are not intended to be used for RF applications.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, and date of this specification.
b. Issue of DoDISS to be cited in the solicitation, and if required, the specific issue of individual
documents referenced (see 2.1).
c. Packaging requirements (see 5.1).
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products
which are, at the time of award of contract, qualified for inclusion in Qualified Products List QPL No. 25516
whether or not such products have actually been so listed by that date. The attention of the contractors is
called to this requirements, and manufacturers are urged to arrange to have the products that they
propose to offer to the Federal Government tested for qualification in order that they may be eligible to be
awarded contracts or order for the products covered by this specification. Information pertaining to
qualification of products may be obtained from Defense Supply Center Columbus (DSCC-VQP), P.O. Box
3990, Columbus, Ohio 43218-3990.
6.4 Assembly instructions. Assembly instructions will include:
a.
Cable preparation-stripping dimensions and tolerances.
b.
List and description of crimping tools if required.
c.
Pictorial presentation of sub-assemblies and loose piece parts.
d.
Sufficient pertinent dimensions for verification of correct parts; as a minimum the cable entry for
conductor, dielectric braid, and jacket will be specified.
e. Recommended cable clamp tightening torque (if applicable).
6.5 Specific requirements. If a specific requirement specified in the general specification is not required
for an item; it should be so indicated on the specification sheet.
28
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business