MIL-DTL-55116 Connectors: Miniature Audio, Five-Pin And Six-Pin General Specification ForThis specification covers waterproof, polarized, five and six contact electrical connectors \(plugs and receptacles\) for use in audio frequency circuits at 60 volts maximum potential and 0.5 amperes maximum current.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21

MIL-DTL-55116D

NOTES:

Two pierces to be coined so that cross section is tapered as shown.

O.D, of termination assembled to T-2049 tinsel cord to be force fit into .088/.086 ID.

Gap width to be adequate to allow insertion of termination assembled to cord into .088/.086 ID.

Scrap from cut off chaining link must extend no more than .020 from inclined front face.

External dimples or embosses or forming burr for retention of termination in contact may be

located on this portion of periphery.

6. Termination to be formed into approx. "U" as shown above. Wire to be pushed down onto

pierces and sides closed to form a cylinder.

7. Material to be quarterhard brass 0.011 inch thick; final plated with copper flash.

8. Dimensions are in inches. Metric equivalents are given for information only.

Inches

.005

.127

.010

.254

.015

.381

.037

.9398

.043

1.0922

.045

1.143

.052

1.3208

.058

1.4732

.089

2.2606

.095

2.413

.195

4.953

.201

5.1054

FIGURE 2. Diagram for termination of tinsel cord - Continued.