MIL-STD-1554A
w/CHANGE 1
4. GENERAL REQUIREMENTS
4.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible, provided that the materials meets or exceeds the operational and maintenance requirements, and promotes economical advantageous life cycle costs.
5. DETAILED REQUIREMENTS
5.1 Dimensions. Dimensions shall be in accordance with the applicable section of this standard and the following dimensional data:
a. Dimensioning and tolerancing in accordance with ASME Y14.5. Dimensions are true position (TP) and in inches.
b. Metric equivalents (to the nearest .02 mm) are given for information only and are based upon 1 inch = 25.4 mm.
c. Dimensions and markings for insert arrangements are shown for engaging face of socket insert; pin insert is opposite.
d. The following tolerances apply to an insert installed in the connector shell:
1. Center of each hole in the insert shall be located at true position within
.014 inches (0.356 mm) diameter.
⊕ .014 DIA
2. Center of engaging end if each contact shall be located at true position within
.024 inches (0.610 mm) diameter.
⊕ .024 DIA
e. |
Unless otherwise indicated, dimensions are symmetrical about centerline (CL or |
). |
f. |
An arrow � indicates the centerline of the insert arrangement. |
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business