MS24265 Connectors, Receptacle, Electrical, Single Hole Mount, Miniature, Classes E, F, G, H And R

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23

MS24265R

NOTES:

1.   Dimensions are in inches.  Unless otherwise specified, tolerances on decimals is ± .005.

2.   Metric equivalents are given for general information only.

3.   All diameters to be concentric with each other within .015 T.I.R.

4.   All diameters in the same plane to be concentric with each other within .004 T.I.R.

5.   True position (T.P.) tolerances specified are for maximum material conditions (M.M.C).

6.   Distance between end of shell and the point at which a gauge pin having the same basic diameter as the mating contact and a square face, engages socket contact spring.

7.   Dimensions on pin and socket contact locations and end of shells to insert faces apply when contacts are placed in inserts for inspection or application.

8.   Dimensions .133 may reduce to .118 minimum under pressure caused by molded cable assemblies or sharp cable bends.  Use tool MIL-I-81969/17 to assemble contacts into this connector, and use tool MIL-I-81969/19 to remove contacts from this connector.

9.   Thread relief groove is optional on shell. When groove is omitted, the length of full thread from front of shell will be .310 minimum and thread runout .385 maximum.

10.  Thread relief groove is optional on shell. When groove is omitted, the length of full thread from rear of shell will be .221 minimum.

11.  Environment resistant (class F and R) receptacles, type T aluminum shell material. Grounding environment resistant (class G) receptacles, type T aluminum shell material. Environment resistant (class E) receptacles, type T, stainless steel shell material. These receptacles mate with plug MS24266 type T.

FIGURE 1.  Receptacle threaded for classes F, G and R - Continued.

4