MIL-DTL-55235A
3.20.1 Mechanical. After exposure to the salt spray test (see 4.7.13), the coupling sleeve shall
meet the requirements of 3.5.
3.20.2 Electrical. After exposure to the salt spray test (see 4.7.13), the contact resistance of the
inner and outer contacts of the connectors shall be a maximum of 0.004 and 0.0005 ohms respectively,
and the contact resistance limits of the adapters shall be 0.008 and 0.001 ohms respectively, when
measured as specified in 4.7.5.
3.21 Moisture resistance. When tested as specified in 4.7.14, the connectors shall meet the
requirements of 3.13 and 3.14.
3.22 Vibration and shock. When tested as specified in 4.7.15 and 4.7.16, there shall be no
evidence of cracking, breaking, or loosening of any of the component parts of the connectors and there
shall be no evidence of interruption of electrical contact of the mated connectors.
3.23 Workmanship. Workmanship shall be such as to permit the connectors to meet all the
requirements of this specification. The connectors shall be processed in such a manner as to be uniform
in quality, and shall be free from sharp edges and burrs, except where sharp edges are required for
mechanical or electrical reasons. All solder joints shall be thoroughly cleaned.
4. VERIFICATION
4.1 Responsibility for inspection. Unless otherwise specified in the contract, the contractor is
responsible for the performance of all inspection requirements as specified herein. Except as otherwise
specified in the contract, the contractor may use his own or any other facilities suitable for the
performance of the inspection requirements specified herein, unless disapproved by the Government.
The Government reserves the right to perform any of the inspections set forth in the specification where
such inspections are deemed necessary to assure supplies and services conform to prescribed
requirements.
4.2
Classification of inspection. The inspection requirements specified herein are classified as
follows:
a. Preproduction inspection (does not include preparation for delivery), (see 4.3).
b. Inspections covered by subsidiary documents (see 4.4).
c. Conformance inspections.
(1) Conformance inspection of equipment before preparation for delivery (see 4.5).
(2) Conformance inspection of preparation for delivery (see 4.6).
4.3 Preproduction inspection. This inspection will be performed by the Government unless otherwise
specified in the contract. It shall consist of the preproduction inspection specified in table I, the inspection
specified in the subsidiary documents, covering the items listed in 4.4, and the inspection specified for
group A, group B and group C (see tables II, III and IV respectively).
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business