MIL-DTL-2036E
Painting of equipment exterior, if gray appearance is required (see 3.2.1).
(c)
(d)
Eddy current magnetism for equipment installed on nonmagnetic minesweepers (see 3.2.3).
(e)
Require an interlock that will cause the interruption of the electrical circuit is an explosionproof
enclosure when the cover or door is removed. The interlock (or other circuitry) will prevent
automatic reenergizing of the enclosure circuit when the explosionproof integrity of the enclosure
is reestablished.
Interface requirements (see 3.2.18).
(f)
(g)
Salt spray (see 3.2.19).
High impact shock and vibration requirements (see 3.2.19 and MIL-S-901 and MIL-STD-167-1).
(h)
Electromagnetic interference requirements of MIL-STD-461 if applicable (see 3.2.19).
(i)
(j)
Type and color of identification and information plate required (see 3.4).
(k)
When dark adaptation is required, the individual equipment specification or purchase document
should so specify (see 3.4.5.5).
Drawings (see 3.5).
(l)
(m)
Quality assurance provisions (see section 4).
Quality inspection system (see 4.4) that should apply, if other than the contractor's standard
(n)
inspection system.
(o)
Examination, tests, and sampling (see 4.4).
(p)
Packaging (see section 5).
(q)
Ordering data to be specified on Form DD 1423.
(r)
Guidance should be included in the individual equipment specification which will assist the
contracting activity in the preparation of CDRL (DD Form 1423) and the citing of appropriate
DID's (DD Form 1664) as applicable to the particular equipment and type or purchase.
6.4 Requirements applicable unless otherwise specified. Attention is directed to the following
requirements which will apply unless specific exception is taken or other requirement is specified in
enclosures specifications. Requirements in this category were written for most of the equipment covered
by this specification recognizing that for certain equipment or under specific circumstances, changes may
be advisable or necessary. Particular consideration should be given to the following subjects when
preparing equipment specifications:
(a)
Whether totally enclosed enclosure is to be convertible to watertight (see 3.2.15.3).
If air coolers are other than as specified in MIL-C-19836 (see 3.2.16.1).
(b)
(c)
If the color style of plastic plates is other than style II of MIL-DTL-15024 (see 3.4.4).
Where the explosionproof design evaluation data is to be submitted (see A.4.1.1).
(d)
6.5 International interest. Certain provisions of this specification are the subject of international
standardization agreement ABCA-NAVY-STD-21A. When amendment, revision, or cancellation of this
specification is proposed which will modify the international agreement concerned, NAVSEA will take
appropriate action through international standardization channels including departmental standardization
offices to change the agreement or make other appropriate accommodations.
6.6 Subject term (key word) listing.
Airtight
Dripproof
Dustproof
Dusttight
Explosionproof
Splashproof
Spraytight
6.7 Changes from previous issue. Marginal notations are not used in this revision to identify changes
with respect to the previous issue due to the extensiveness of the changes.
17
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business