MIL-DTL-24231E(SH)
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as follows:
a.
First article inspection (see 4.2).
b.
Conformance inspection (see 4.3).
4.2 First article inspection. First article inspection shall be performed on sample units which have been
produced with equipment and procedures normally used in production. When specified (see 6.2), a first article
inspection report shall be prepared (see 6.3).
4.2.1 Sample size. One complete pressure-proof fitting assembly or one single item (see 4.5.12) of each
military part number shall be subjected to first article inspection. Where applicable, the sample shall be furnished
with an approximately 1-foot length of cable or wire, wired and molded as required by 3.1.
4.2.2 Inspection routine. Samples shall be subjected to the first article inspection specified in table I, in the
order shown.
4.3 Conformance inspection.
4.3.1 Inspection of product for delivery. Inspection of product for delivery shall consist of groups A, B, and C
conformance inspections specified in table I. When specified (see 6.2), a conformance inspection report shall be
prepared.
4.3.1.1 Inspection lot. An inspection lot shall consist of complete pressure-proof fittings or single items
(see 4.5.12) of the same military part number, produced under essentially the same conditions, and offered for
inspection at one time.
4.3.1.1.1 Disposition of sample units. Sample units that have been subjected to group C inspection shall not be
delivered on the contract.
9
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business