MIL-STD-1554-SUP Insert Arrangements for MIL-DTL-83723 Series III and MIL-DTL-26500 Environment Resisting, Circular, Electrical ConnectorsThis standard covers insert arrangements for use with MIL-DTL-83723 series III and MIL-DTL-26500 environment resisting, circular, electrical connectors.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59

MIL-STD-1554A

5. DETAILED REQUIREMENTS

5.1 Dimensions. Dimensions shall be in accordance with the applicable section of this standard and the following dimensional data:

a. Dimensioning and tolerancing in accordance with ASME Y14.5M. Dimensions are true position and in inches.

b. Metric equivalents (to the nearest .02mm) are given for information only and are based upon

1 inch = 25.4mm.

c. Dimensions and markings for insert arrangements are shown for engaging face of socket insert; pin insert is opposite.

d. The following tolerances apply to insert installed in shell:

1. Center each hole in insert shall be located at true position within

.014 dia.

⊕ .014 DIA

2. Center of engaging end if each contact shall be located at true position within

.024 dia.

⊕ .024 DIA

e. Unless otherwise indicated, dimensions are symmetrical about centerline (CL or CL). f. An arrow � indicates the centerline of the insert arrangement.