MIL-STD-16988
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. DEFINITIONS
3.1 Definitions. The terms used in this standard are generally accepted by the electrical and electronics industries and commonly used in electrical connector engineering practice.
4. GENERAL REQUIREMENTS
4.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible, provided that the materials meets or exceeds the operational and maintenance requirements, and promotes economical advantageous life cycle costs.
5. DETAILED REQUIREMENTS
5.1 Dimensions. Dimensions shall be in accordance with the applicable section of this standard and the following dimensional data:
a. Dimensioning and tolerancing in accordance with ASME Y14.5M. Dimensions are true position and in inches.
b. Metric equivalents are given for information only.
c. Dimensions and markings shown are for engaging face of pin insert. Socket insert is opposite.
d. The following tolerances apply to insert installed in shell:
1. Center of each hole in insert for crimp contact connectors shall be located at true
position within .010 dia.
⊕ .010 DIA
2. The center of engaging end of each contact shall be located in true position within
.018 dia.
⊕ .018 DIA
e. Unless otherwise indicated, dimensions are symmetrical about centerline. � indicates eL
of insert arrangement.
f. Each insert is shown in the "normal position" in the shell. g. Polarization shall be in accordance with MIL-DTL-28840.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business