INCH-POUND
MIL-DTL-83502E
14 December 2007
SUPERSEDING
MIL-DTL-83502D
10 February 2004
DETAIL SPECIFICATION
SOCKETS, PLUG-IN ELECTRONIC COMPONENTS, ROUND STYLE,
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers round, plug-in electronic component sockets for use on panel
boards, printed circuit boards, and microelectronic components (see 6.1).
1.2 Part or Identifying Number (PIN). The PIN consists of the letter M (see 3.8), the basic specification
number, a forward slash, a detail specification number, a dash, and a number for the socket arrangement
shown in the following example:
83502/
1
-002
M
Dash numbers assigned in a
specific specification sheet
Detailed specification sheet
Basic specification number
M prefix
1.2.1 Classification. Sockets covered by this specification are of the following types as specified (see
3.1). For the purpose of clarification in this document and the references cited herein the socket's
mounting types are defined as follows.
Wrappost (see figure 1).
a. Type I
-
Printed circuit terminals (see figure 1).
b. Type II
-
Wire turret terminals (see figure 1).
c. Type III -
d. Type IV -
Solder-cup terminals (see figure 1).
Comments, suggestions, or questions on this document should be addressed to: Commander, Defense
Supply Center Columbus, Attn: VAI, P.O. Box 3990, Columbus, Ohio, 43218-3990 or emailed to
RectangularConnector@dscc.dla.mil. Since contact information can change, you may want to verify the
currency of this address information using the ASSIST Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5935
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business